There are some simple home projects that do not need to go and a few expensive contractor or carpenter's room. One of these, you can do is a fence for your garden.

Relax, make a fence all by yourself is an exciting adventure, and should not be difficult or impossible. If we are not all that consistently, it should not be too difficult. The construction of a wall that we have the right design for a mission needs.

The creation of a fence ourselves in the firstthings we need to do is by design. This means that we must take accurate measurements to the width of opening, in which you want to vote against the wall. We also consider the height of the fence around it. Everything must be complementary, after all we want form and function, right?

So we buy the necessary pieces of wood 4 by 4 inch lock and hinge seats, door frames measuring 2 by 4 inch pieces of wood picket of 1 to 2 cm. These are just suggestions, sizes vary depending on the woodour project wood fences. We also need screws, nails, 3 to 4 sets of hinged and closure. The size and number of pieces depends on the size of the enclosure.

We dig holes for the lock and hinge positions. A depth of 3 meters, more or less should do. Connect one end of posts in the holes and reinforce with the rocks and soil intact on the sides to leave the yard. O poured concrete on the sides. So we have horizontal framework for the installation of fence installed gateways. We also fixStuck at the gate hinge line.

Then we have the frame diagonally to install. Addresses many fine-tune the chassis horizontally. To attach, holes through them, and the horizontal frames and insert a long screw. Mark the spots that are distributed evenly, the pickets. Use a square. Then attached to the wall with nails or screws at their lower part. Two screws or nails, will each make.

Finally, re-installation of the fence. Open Gate for Forestfor a smooth and precise localization of scratching the extra thickness of the wood. Then back to the elevator to connect the hinges back permanently. Make sure that the wooden door to open and close the door and out of style or arrest properly.

It is better to make the fence right where we are planning to install. This allows us to measure the actual need and lower size wooden gate of it. Handle carpentry tools and equipment with care and be sure to wear gloves when assemblinghammering nails, driving screws, or cut with a saw.

Ensure that all equipment is in good condition to ensure that the chisel or flat blades are sharp. Sharp tools make work easier and safer. Use a carpenter's apron, if needed.

It's exciting to make our own wood fence. We can begin to experiment with our garden gate.